I'm trying to run IMR4046 through this thing and it keeps getting caught on powder. Is this only really designed for ball type powder and not stick type powder?
I'm trying to run IMR4046 through this thing and it keeps getting caught on powder. Is this only really designed for ball type powder and not stick type powder?
Sometimes it has to cut through a piece of powder, that is the stuck feeling your are getting.
JTD
That is typical of stick powders in most all measures. Not much you can do about it except set to drop low and trickle up.
Big Eddy
Not big and tall but big and round
Thanks. I'll have to give that a try. I figured there was a trick to it but wasn't sure what.
Also the RCBS Uniflow measure has a larger drop tube that can help with bridiging. Turning the measure around and seting the handle to drop on the down stroke may help as well.
Last edited by Big Eddy; 01-09-2019 at 04:22 PM.
Big Eddy
Not big and tall but big and round